KSI ECOCONTROL
With KSI into the age of „Industry 4.0“
The online system management ECOCONTROL provides access to the age of „Industry 4.0“: The specialist dealer is in a -position to monitor small to large plant concepts online, to carry out prevention by analysing the information displayed, to receive critical values signalled at any time and anywhere and finally to plan the service of all components in a strategically sensible manner.
The ECOCONTROL Plus-Effects +++
- prevention through optimized service and deployment planning
- detect critical situations online at any time
- alarm acknowledgement and online configuration: no unnecessary trips to the plant
- no access to end customer data by KSI
- data logging and visualization of current and past values (without limitation of data volume)
- warnings and fault messages by email
- service parts (also for third-party products) for all system components with maintenance interval pre-defined or storable
- private label version for end customer presentation (optional)
- additional data boxes allow the connection and -definition of a variety of sensors
- switching of electrical components over defined -conditions
- software as web app: no installation on end devices necessary ▶ Access with any Internet-enabled end device
- databases and servers at German locations, encrypted connection between server and user device
- individual system configuration as PID representation
ECOTROCONOMY-Comfort (ETC 4.0)
- available as an option for the entire ECOTROC® AT series
- all ECOTROC® AT adsorbers can be easily upgraded (even older models and models from other manufacturers)
- dew point measurement and display up to -100°C
- demand-based regeneration control by measuring the operational conditions
- integrated variable load counter (facilitates possible vessel inspections at a later date)
- storage of the operating parameters together with time data (retained and restored after power failure)
- Password protection on all levels (can be changed)
ECOTROCONOMY-Premium (ETP 4.0)
ET-C functions:
- available as an option for the entire ECOTROC® AT series
- all ECOTROC® AT adsorbers can be easily upgraded (even older models and models from other manufacturers)
- dew point measurement and display up to -100°C
- demand-based regeneration control by measuring the operational conditions
- integrated variable load counter (facilitates possible vessel inspections at a later date)
- storage of the operating parameters together with time data (retained and restored after power failure)
- Password protection on all levels (can be changed)
plus in addition:
- pressure measurement at the dryer inlet, and indicator on the control display
- Temperature measurement at the dryer inlet, and indicator on the control panel
- safety shutdown in the case of deviation from specified values is possible
ECOMATIC
Standard scope of supply with all ECOTROC® AT (heatless regeneration)
- display of adsorption/regeneration cycle
- fully electronic micro processor
- energy-saving compressor synchronizing circut
- variably adjustable cycle times (selectable)
- status display and potential-free alarm signal for service requirements
- 24 V optional
- can be used for adsorption dryers from other manufacturers
